I actually have version 10.3 server installed, but I did not see a forum for that version so I am posting it here. For starters, this software is installed on the following system:
Windows Server 2008 Standard Edition (32 Bit) - SP2
AMD Phenom 9550 Quad Core
After installation everything seems fine. However, the following problems are occurring:
1. When I initially open the application and subsequently close it, I am unable to open it back up (either from the tray control or the start menu). I have to go to task manager and end NovaBackX.exe then I go to the start menu and start the application again. I can get a backup to successfully complete, but the data on this server is extremely important and I cannot have this application operate in this manner.
2. The TrayControl seems to not be in Sync with what the application is currently doing. For example, the backup was running and the TrayControl was green?
It seems to me that something installed incorrectly. This is entirely unacceptable (considering the cost of the software) and I would like to figure out what is going on.
I have tried the following solutions (none have worked):
1. Uninstalled NovaBackup 10.3 Server, and then Reinstalled the software
2. Ran 'sfc /scannow'